Emission Labs EML 300B Mesh Version Matched Pair

€719.95
In stock

Emission Labs 300B Mesh - matched pair

This mesh version from Emission Labs is, just like the Western Electric original, hand-crafted in the Czech Republic in small quantities and with the highest quality.
This 300B from Emission Labs tubes is used in the very best SET tube amplifiers and is seen as the most beautiful 300B.
Set of two pieces.

DELIVERY TIME 1 WEEK

This item is in stock;
Ordered before 16 PM will be shipped the same workday;
All prices are including VAT;
Need help? Please contact us.

More Information
Tube type 300B
Manufacturer/Brand Emission Labs
Production New
Tube kind Powertube
Construction Power Triode
Pin Layout 4 pins
Country of Manufacture Czech Republic

Emission Labs 300B Mesh version
The 300 was originally developed by Western Electric in 1933 in the famous Bell Labs as 300A.
in 1938 the bayonet pin turned 45 degrees in position and became a 300B. Buis supplies 8 Watt single ended and 15 Watt in Push Pull configuration.
These power triodes have gold-plated connections.
This Mesh version from Emission Labs, as the Western Electric original, is manufactured manually in the Czech Republic in small quantities and with the highest quality.
This 300B from Emission Labs tubes is used in the very best SET tube amplifiers and is seen as the most beautiful 300B.

Emission Labs
Emission Labs is a vacuum tubebrand established in May 2000, with production in the Czech Republic. Building on the production of the high-quality Tesla vacuum tubes and VAIC SET amplifiers, we now fully independent craft our EML tubes.
Our goal is to deliver the best sounding triodes, with the highest possible mechanical and electrical quality and we support that through our 5-year warranty program.
We have all critical processes in house, use hard metal for all critical parts of the tube and produce every part and piece itself, the entire glassware and the gold-plated connections of the tube base. All our tubes have only a failure rate of less than 0.5 percent.

Matched tubes
This set of tubes is matched. This means that the measured values of the tubes fall within the same range and thus perform equally.
This is important for two reasons:
1. To obtain the same gain factor per tube.
2. For the same amount of quiescent current per tube.
The first requirement speaks for itself and the second requirement prevents the one tube where a higher quiescent current or bias is needed to make it work in the linear region will also be worn out earlier. Both new tubes and our NOS tubes can be ordered separately.